Specification Specification tank tank module: (1) 1000 × 1000 × 1 (2) 1000 × 1000 × 1.2 (3) 1000 × 1000 × 1.5 (4) 1000 × 1000 × 2 (with less) (5) 1000 × 500 × 1 (6) 1000 × 500 × 1.2 (7) 1000 × 500 × 1.5 (8) 1000 × 500 × 2 (with less) (9) 500 × 500 × 1 (10) 500 × 500 × 1.2 (11) 500 × 500 × 1.5 (12) 500 × 500 × 2 (with less) wherein a thickness of 1mm for the cover, 1.2mm for the upper plate, 1.5mm for the middle of the side plates, 2mm for the lower side board. 2mm backplane with the entire board. Base design considerations should lead to the bottom of the tank vent pipe, the base generally use 14 # channel, middle channel line up with the same one meter square grid. KQF series in the corresponding steady flow tank installation position welding same channel, and pre-drilled mounting holes steady flow tank. To lead the vent pipe on the side of the channel position reserved for φ70 hole for vent pipe (DN50) through. Annex --φ550 tank manhole manholes, made 1000 × 1000 × 1.5 module, there are two escalators in the side to do the climb ear hole φ12. There are lockable mechanism. Escalator - polished stainless steel using 30 × 30 or 36 × 24 square tube polished stainless steel rectangular tube production, width 380mm, height of each section 300mm, leave the box from the 220mm. The upper portion of the human ear hole to climb M10 bolt connection, the lower portion of the housing and cover ground at the contact of rubber or plastic sleeves (such as ready-made products can not be found to cancel). At least at the side of the tank R1 / 2 interface, then 1/2 ball after loading level sensors, sensor accuracy 0.1m, the maximum range of <5m. Internal reinforcement ribs to 40 × 30mm channel, with the stainless steel scrap folded. Gradually flattens the tank module tank during the four corners of each piece welds tank module, should the tank and the tank opposite corner modules to be reliable seam welding, in order to ensure the overall strength of the tank. Ribs are staggered at the intersection, but not bent.